Orienting station for gluing of center pieces on ingot axis.
GLUING STATIONS
APPLICATIONS The equipment is dedicated to control the gluing of an ingot on a saw work holder so that it si glued parallel to or with a defined angle with respect to the side datum of the work holder. The orienting station can be used for measuring the actual orientation of a glued single ingot or of multiple ingots. Options also available : Dual axis orientation Gluing of center pieces on ingot axis Orientation of the ingot by using the ingot face as reference.
Gluing stage : To glue of the ingot on an epoxy or glass beam.
Orienting station for wire saw cutting
FEATURES Ingot correction range : approx. 5 degrees at max. ingot length. System total accuracy : better than 0.05°( possible higher accuracy configurations) Measurementr accuracy : better than 0.01mm and 0.01° Display resolution selectable Measuring gauge and linear encoder are connected to a data acquisition board inside of a PC. A dedicated software enables the display of measured values as well as the resulting angles.
Orientation of ingots on a wire saw hol-der by using the in-got face as a refe-rence.
The goniometric orientation process consists in rotating the ingot about its axis so that the cutting plane remains vertical. The orientation station enables gluing of such ingots rapidly and accurately on a saw work holder, the angular orientation in the horizontal plane being easily, accurately and rapidly controlled in real time.
Capacity : Ingot Ø : 50 to 300 mm Ingot length : up to 450mm
Home CONTACT PRODUCTSdelta technologies int'l